Jeżeli wycieraczki w trybie AUTO działaja jak chcą to trzba je skalibrować w prosty sposób...
Zapłon na OFF, wycieraczki na AUTO, zapłon na ON. nastepnie w ciągu 10 sek. przestawiamy 5 razy manetkę z AUTO na OFF. Udana kalibracja powinna być potwierdzona pojedyńczym wachnięciem wycieraczek.
Szyba powinna być sucha i czysta. Pokrętło prędkosci na minimum. Dobrze zmienić wycieraczkę pasażera która czyści okienko sensora na nową.
Skan z instrukcji kalibracji po angielsku
AIN SENSOR REINITIALIZATION SETTING
Caution
If the initialization is performed again with water or dirt on the windshield, the rain sensor may not
operate normally. Before performing the rain sensor initialization again, remove water and dirt
from the windshield
Note
When the ignition switch is turned to the ON position after replacing the rain sensor with a new one, the
windshield condition is verified and the initial setting is stored.
Perform the initial setting again in the following cases:
— The windshield is replaced and the rain sensor is reused.
— The auto wiper system operates incorrectly.
1. Remove water and dirt from the windshield surface.
2. Switch the ignition to off.
3. Turn the windshield wiper switch to the AUTO position.
4. Within 10 s after turning the ignition switch to the ON position, turn the windshield wiper switch from the AUTO
to the OFF position for 5 times and return it to the AUTO position.The windshield wiper will operate once at
low speed when the reinitialization setting is performed correctly.
Caution
If the operation is too fast, the windshield wiper switch position cannot be detected and the initial
setting may not be performed. Operate the windshield wiper switch for one cycle
(AUTO->OFF->AUTO) per 1 s.
Powodzenia